MOULD LOFT

  • Partial reproduction of a mould room floor with the outlines of several frames.

  • Table used in the workshop to set up the articulated specific levels, which were used in the modeling of the hull shell plates during the ...

  • Educational automaton that spreads the frames along the length of the ship.

  • Reproduction of the instrument used for defining top levels of a piece based on its model at a 1:10 scale. This information is later used ...

  • First machine ev er used for the production of scale models of ships to be tested in the El Pardo Model Basin. ...

  • Three plans showing the construction of the ship Real Felipe.

  • Half hulls used between 1900 and 1975 in the shipyard’s Technical Office to define the outlines of the strakes that form the hull shell. ...

  • Named after its inventor, Sprague Stanley, this integraph is a mechanical instrument used to calculate section areas of a ship directly off plan. ...

  • Olivetti computer composed of screen, keyboard, disk unit and punched card reader/writer. It was among the first personal computers available on the market. ...

  • Hand tool, similar to a hammer but larger and heavier, used to counter the blows of the riveter from outside the hull. ...

  • Firts hard disk with integrated heads, used in the IBM 360 and 370 computers, with a capacity of 250 Mb, coeval with punched card equipment. ...

  • Tool used to work on assemblies, frameworks, chisel handles, rivets, etc.

GROUND FLOOR

The Museum begins on the ground floor of the Herrerías building. The first stage of the tour is subdivided into five thematic modules.

SEE SECTION

FIRST FLOOR

The Temporary Exhibition Hall houses pictorial, photographic, and artistic exhibits on themes related to the sea.

SEE SECTION